ANSI/AWWA C200-23美标钢制水管交付条件：1.标记：应在每段管道和每段特殊管道的显眼位置应用序列号或其他识别标记。如果管道有涂层或衬里，则应将此类标记转移到涂层或衬里上。制造商可能需要向买方提供线路图（图纸）或铺设时间表，显示每个编号的管道或特殊部分在管道中的位置。此类图表（图纸）或明细表上的数字应与管道和特殊部分上的数字相对应。2、搬运和装载：涂层或衬里管道的运输和搬运应符合买方文件的要求，如果没有买方文件，则应符合管道制造商的建议。应使用适当的设备搬运管道，并防止变形或损坏。不允许使用可能使端部扭结或弯曲的钩子或夹具。加载方式应防止任何管道长度上的凸起，例如带有搭接接头的端部或带有橡胶垫片接头的钟形物和龙头的端部，相互摩擦或与另一段管道摩擦。

Delivery conditions for ANSI/AWWA C200-23 American standard steel water pipes: 1. Marking: Serial numbers or other identification marks should be applied in prominent positions on each section of the pipeline and each special section of the pipeline. If the pipeline has a coating or lining, such markings should be transferred to the coating or lining. Manufacturers may need to provide the buyer with a circuit diagram (drawing) or laying schedule, showing the location of each numbered pipe or special part in the pipe. The numbers on such charts (drawings) or schedules should correspond to the numbers on pipelines and special sections. 2. Handling and loading: The transportation and handling of coated or lined pipelines shall comply with the requirements of the buyer's documents. If there are no buyer's documents, they shall comply with the recommendations of the pipeline manufacturer. Appropriate equipment should be used to handle pipelines and prevent deformation or damage. Hooks or clamps that may cause twisting or bending of the ends are not allowed. The loading method should prevent any protrusions on the length of the pipeline, such as the end with overlapping joints or the end of the bell and faucet with rubber gasket joints, from rubbing against each other or against another section of the pipeline.